I have internal bullhorns. Good to know. Thanks Bob.

You would think so but there was no indication of a problem at taxi speeds.

For car tires, I lay a 2 X 6 up against the rim and drive a car up on it. No arguemets so far !!!!!! 😄😄😄😄 GM

Hi all, I have ordered an engine mount from the Cozy girls for my Cozy project. Chrissi was kind enough to accept bringing it to Rough River so I can pick it up myself. Unfortunately I will not be

Harley, What are the half dozen bright red triangles in your screen shot (some over obstruction symbols, some not)? Tony

Well after all the conversations about breaking the bead, I thought I would offer my efforts for success. I ran into the problem with the split rim tires on my CGS Hawk. The problems I had were two

I've purchased (and will be installing) a uAvionix Echo for my ADS-B receiver and transmitter. So, the Open Flight Solutions Flight Box that I have should find a happier home! I never used it

I tired a number of different ways to get the pesky tire of the rim, but found simple and cheap to be the easies..… A 2x4, and steel ring (slightly larger than the rim) and a bolt on the wall.

As often as not a tire will slide right off of a rim w/o undue effort.?? Flip side of that situation is that if a tire has been on the rim for a year or three, it can take some serious

All we have learned about NACA duct placement...... ---------- Forwarded message --------- From: Hagerty News <email@...> Date: Tue, Sep 24, 2019 at 10:46 AM Subject: The 10 coolest cars with NACA

You want a fluorescent fixture I have one you can borrow. Greg

Lay a hunk of plywood on the ground, get an 8 foot 4x4, put your wheel on the plywood and wedge the 'backside' so it cannot rise with some other wood/2x4 hunks, put the end of the 4x4 under a

Perhaps I should have ben more explicit. To use a screwdriver you 'twist' the screwdriver about its long axis. A bit basic but there you are. Do not use the screwdriver as a 'lever'. The inner faces

Split or non split. Any difference? Keep the wheel together break bead first then separate. With single piece wheels after breaking the beads on both sides you need to stretch both beads over one

WoW! Thank you Dick and special thanks to all the Rutan Aircraft Flying Experience members and every one else that made the Rutan Reunion Flight of AIrVenture 2019 possible! See y'all at Rough

Thanks for the reveal! What a wonderful surprise! I’d love to get a look at some of the other shots taken that morning. We did tons of shots in different formations and backgrounds. I’d be

A very nice tribute to Dick!

Hello all, I am a non-builder Long-Ez pilot. My rudder return spring recently snapped and I am looking for any information on the spring – length, gauge, where I can buy one. Also, without

Hi, everyone: With the October issue of Sport Aviation’s digital format going live tomorrow (9/25), I wanted to give you a little advance sneak-peek at the cover. I think you’ll like it. Thanks

Yes usually difficult on 2 piece wheels Keith