toggle quoted messageShow quoted text
Here's the pic. of the speed brake gas strut replacement for those horrible springs. I did this at least 10 years ago and it still works fine. I hadn't looked at it in all that time and had forgotten how simple it was to do using all the existing hardware. Don't ask me details about the strut - I can't remember.
On Fri, May 15, 2020 at 4:05 AM Terry Schubert <jschuber@...
Thanks for the tip for an alternate spring breaking reason.
I get Century springs from Ace Hardware and haven't run into that.
---------- Original Message ----------
From: "Steve" <josteve100@...
Subject: Re: [Canard Zone] Long-Ez Speed Brake spring tension
Date: Thu, 14 May 2020 18:38:55 -0400
The spring in the pictures look like screen door return springs that are easy to get at Home Depot or Lowes. I got one from Lowe’s last month that I was going to stretch out and wrap around the exhaust under the carb heat muff. It broke in three places as I stretched the spring. I then purchased one from Home Depot that was a different brand. I was able to stretch the new one without breaking. I don’t have the packaging anymore but it’s clear that some brands are making very brittle springs.
On Thursday, May 14, 2020, Terry Schubert <jschuber@...
Many people set the landing brake spring tension ungodly high. STOP that!
It is dangerous for the GIB when a spring breaks and hard for the pilot to open during normal operation.
The brake should blow shut above 95 kts to prevent structure damage. That closing pressure is to be controlled by length of the slot in the floor NOT by adding monster spring tension. Study the geometry. The push rod and the linkage should never be near straight or ever over center.
If your brake doesn't blow shut by itself at 95 kts then the floor slot is too long - shorten the slot so as to limit forward travel of the push rod. That lowers the required spring pressure. The plans spring is PLENTY strong.
Spring wire is sensitive to scratches and is more likely to break when scratched by pulling pliers that have slipped off the end of the spring or by folks that have attempted to reform the hook on the end. An excessively sharp bend increases the chance of spring failure.
retired Central States Association Newsletter Editor
Please note: message attached
From: "Filipe Rosa" <filiperosa@...
Subject: [Canard Zone] Long-Ez Speed Brake spring tension
Date: Thu, 14 May 2020 12:53:54 -0700