Re: (Canard Zone) Flush door handles

Don B

I don’t lock mine.  I don’t want someone to break the Canopy to steal my radio!

On Jan 23, 2020, at 1:17 PM, Keith Spreuer <kspreuer@...> wrote:

Oh I see. So do you have anyway to lock it from the outside? I don't on mine either but perhaps that would be nice.


On Thu, Jan 23, 2020 at 12:15 PM Bill James <bill@...> wrote:
Arms the ejection seat. 

Actually Previouslyused to activate the canopy micro switch. 

On Jan 23, 2020, at 11:53 AM, Keith Spreuer via Groups.Io <> wrote:

I was referring to the rod further up. Looks to be about an inch from the pivot. It has a slight bend and goes thru the IP. Isn't that an exterior lock?


On Thu, Jan 23, 2020 at 8:35 AM Bill James <bill@...> wrote:
Keith, the wire ends are simply bent 90 degrees. The strength and tension of the wire, 3/16 stainless welding rod, has held it in place 23 yrs. i May have put some flox in the holes. It is a little busy fwd of the panel with the micro switch right there. The welding shop only sold the rods by the pound so he just gave me one rod. Another strong type wire or rod would work. The simple solid mechanism has worked well.As you know the exterior canopy lock doesn’t have to be located right there using that catch. :)

On Jan 22, 2020, at 4:29 PM, Keith Spreuer via Groups.Io <> wrote:

Got a photo of the locking part of the unit forward of the instrument panel?


On Wed, Jan 22, 2020 at 2:08 PM Bill James <bill@...> wrote:

Simple Canopy Latch 
The lever latches into the lower catch, locking the canopy.

Key elements:
The head of the lower “handle” bolt catches into the center of the lower wire element.

The original lever was moved forward. A new catch was installed to replace the lever and catch the fwd canopy catch. An extension connects them. The lever latches into the lower element but does not catch the canopy, so it does not need the top hook any more.

The lower wire catch element is 3/16 stainless welding rod. No sharp edges :)  The smaller center loop simply goes through the panel and is bent and held on the forward side. The outer loop was swaged on, expecting to be needed to aid hooking the lever bolt head. However, once the three canopy latches are in place, the latching movement is simply to push the “handle” forward a little and move the lever left, to hook the head into the center wire element. 
The thin black oval on the inside of the center loop is the extended arm from the micro switch for the canopy/gear/throttle relay.


On Jan 21, 2020, at 4:07 PM, Curtis Martin via Groups.Io <rebflyer@...> wrote:

Going with the kiss method,  
Picture the standard canopy latching system front    ….snip

Join to automatically receive all group messages.